door lock RENAULT TWINGO 2009 2.G Chasiss ABS Workshop Manual

Page 13 of 76

38C-13
MR-413-X44-38C000$376_eng.mif
V1
38C
ANTI-LOCK BRAKING SYSTEM
Diagnostics - Configuration and Programming
SETTINGS
VP001: Enter VIN.
This command allows the vehicle identification number to be entered into the computer.
Use this command each time the computer is replaced. The VIN (VF...) is engraved on the manufacturer's
plate on the front right-hand door pillar and stamped on the body under the windscreen on the left-hand
side.
VP004: Vehicle parameters.
This command configures the engine type configuration, the braking definition and the body type.
Select command VP004 on the diagnostic tool.
VP006: Write last After Sales operation date.
Whenever the ABS system is worked on in the shop, the date must be entered.
Select command VP006 "Write date of last After-Sales operation" on the diagnostic tool.
Enter the operation date with the tool keyboard.
VP007: Tachometric index.
This command is used to program the computer memory with the index required to calculate vehicle speed
from the speed at which the wheels turn.
The MK70 ABS computer supplies the vehicle speed signal to all areas where this information is needed
(instrument panel, engine management, etc.). This vehicle speed signal replaces the one supplied by the
speed sensor located on the gearbox.
The ABS computer calculates the vehicle speed from the speed of the wheels and the circumference of the
tyres fitted on the vehicle.
The tyre circumference must be programmed into the memory of a new computer. This consists of entering
an index "X" using command VP007 "Tachometric index" on the diagnostic tool.
Once the number has been entered using the VP007 command, delete the fault in the computer memory and then
switch off the ignition. Use parameter PR030 Tachometric index to check that the index entered has been correctly
registered.
CONFIGURATIONS
CF079: Gearbox type.
Use this command to configure the gearbox type fitted on the vehicle.
OTHER COMMANDS
LC008: Gearbox type.
This command tells you the gearbox type configured on the vehicle. Note:
The vehicle speed is delivered by wire (connection 47F) to the radio, to the electric power-assisted steering, to
the electric sunroof and by the multiplex network for the other computers.
MK70 ABS
Vdiag No: 04
MR-413-X44-38C000$376_eng.mif